NCR S26, User Manual, Page: 132 / 220

Sample RAID Configuration
C-14 Sample Configurations
8. Install the PCI Ethernet Adapter in PCI slot 3.
Configuring the System Settings
The procedure is the same as the procedure for configuring the system settings
in the Standard Configuration. The procedure is repeated here for your
convenience.
To configure the system settings, follow these steps:
1. Turn on power to the system. Observe that the memory test is executed
(memory addresses should be rapidly displayed in upper left-hand corner
of screen). Ignore any memory size mismatch error displayed on the
screen.
2. Press Ctrl + Alt + Esc when prompted to enter the BIOS Setup Utility.
3. Select Load System Defaults and press Enter.
Basic System Configuration
1. Select Basic System Configuration. To go from page to page, press Page
Down or Page Up.
2. Go to page 2 and set parameters as follows (in the order indicated):
Fast Boot Mode [Disabled]
Auto Configuration Mode [Disabled]
Memory Test [Disabled]
Num Lock After Boot [Enabled]
Large Memory Support [Advanced]
On Board IDE [Disabled]
Hard Disk Size > 504 MB [Disabled]
Hard Disk Block Mode [Disabled]