NCR RealScan 7875-7000/8000 Installation Guide
AIP-00342 Release B
06/03
49 of 56
Appendix C – Pan-Oston PO-4
This checkstand has a metal side panel next to the scanner position. A hole must be cut in this
panel and covered with a Plastic Side Plate.
1.
Use a saw to cut out a portion of the metal side panel that is 13” long and 3 ½ “ deep. This
should start 1.15” from the front edge of the side panel.
2.
Use two bolts to connect the Cover Rail (NCR Part Number 497-0430977) to the Plastic
Side Plate (NCR Part Number 497-0430978).
3.
Attach the new Side Plate assembly to the checkstand using four screws.
4.
Install a Sensormatic Power Pad Label on the Plastic Side Plate. Remove the paper backing
and place the label in the middle of the Plastic Side Plate.
5.
Go to
Step 2 – Connect the Components
.
