NCR RealScan 7875-7000/8000 Installation Guide
06/03
AIP-00342 Release B
18 of 56
Specific Function Programming
There are several Sensormatic Security Tag Deactivation functions that can be programmed at
the RealScan 7875.
Security Tag Deactivation
This parameter enables or disables the entire Sensormatic Deactivation function.
Enable Security Tag Deactivation
Programming Mode, Hex 4, Hex 2, Hex B, Save and Reset.
Disable Security Tag Deactivation
Programming Mode, Hex 4, Hex 2, Hex A, Save and Reset.
Security Tag Detected Tone
This parameter enables or disables a tone while a security tag is being detected. When enabled
and a security tag is within the detection zone, a continuous beeping tone is produced that
sounds similar to a Geiger counter.
Enable Security Tag Detected Tone
Programming Mode, Hex 6, Hex 2, Hex D, Save and Reset.
Disable Security Tag Detected Tone
Programming Mode, Hex 6, Hex 2, Hex C, Save and Reset.
Deactivated Tone
This parameter enables or disables a tone following a security tag deactivation.
Enable Security Tag Deactivated Tone
Programming Mode, Hex 4, Hex B, Hex B, Save and Reset.
Disable Security Tag Deactivated Tone
Programming Mode, Hex 4, Hex B, Hex A, Save and Reset.
Deactivated Tone Type
This parameter determines the type of tone to produce when a security tag is deactivated.
Series of Tones
Programming Mode, Hex 4, Hex B, Hex E, Save and Reset.
Single Long Tone
Programming Mode, Hex 4, Hex B, Hex F, Save and Reset.
Deactivated Tone Frequency and Length
The Deactivated Tone frequency and length can be adjusted by scanning the appropriate tags.
Each time you scan the Deactivated Tone Frequency tag the tone frequency increases until it
reaches a maximum level. At this point the cycle continues from the lowest level. Each time you
scan the Deactivated Tone Length tag the tone length increases until it reaches a maximum time.
At this point the cycle continues from the shortest time.
