NCR RealScan 7875-7000/8000 Installation Guide
AIP-00342 Release B
06/03
17 of 56
Step 3 – Sensormatic
Deactivation Setup
Power up the System
Note:
Refer to the Sensormatic ScanMax™ Pro Controller documentation for additional
information about setting up the controller.
1.
Turn on the NCR RealScan 7875. When the RealScan 7875 is first turned on, all the
Sensormatic parameters should be at their default settings.
•
RealScan 7875 Scan tone delay until deactivation = Enabled
•
RealScan 7875 Deactivation button = Disabled
•
RealScan 7875 Clicking = Enabled
The RealScan 7875 should give the voice message
EAS Offline
if the Sensormatic
ScanMax
TM
Pro Controller is still turned off. Also, the Red Status Indicator flashes rapidly.
2.
Turn on the Sensormatic ScanMax
TM
Pro Controller. This system is programmed at the
factory with default settings for proper operation.
3.
After the RealScan 7875 and the Sensormatic ScanMax
TM
Pro Controller have both been on
for about 15 seconds, the RealScan 7875 should give the voice message
EAS Online
.
Note:
Voice message
EAS Online
must be given before you can continue. If voice message
EAS Online
is not given, turn off the power to all components. Check all cable connections
then repeat this procedure starting at step 1. If voice message
EAS Online
is still not given
and the Red Status Indicator is flashing rapidly, scan the
Reset
programming tag. If the
status given is still
EAS Offline
, follow instructions on the Sensormatic Card –
Before You
Call About…
The problem may be a bad Antenna cable.
4.
Position a Hard Tag over the top of the RealScan 7875. As you move the Hard Tag, the
RealScan 7875 should start clicking when the tag moves within 4 inches of the center of the
Top Plate. If the clicking sound is not generated, scan the
Reset
programming tag, then go
to step 3. If the second attempt fails, call for help. Refer to
Obtaining Technical Assistance
.
