NCR RealPOS, User Manual

Page: 99 / 187

Chapter 5: Programming 5-53
Miscellaneous Parameters
Host Tone Control
Your Program
Miscellaneous
Parameters
Disable
3
Enable
4
3 2
Host Tone
Control
Speech
Toggle Between Enable
and Disable Speech
D
IBM Retransmit
Control
IBM Retransmit Control
3 Times
7
Forever
8
22813
IBM-485 / IBM-USB Tag
Data Format
Hex
E
ASCII
F
Speech IBM-485 / IBM-USB
Tag Data Format
The Miscellaneous Parameters programming mode controls parameters associated with the
7893 that do not fit easily into any of the other categories. The 7893 firmware is programmed
to accept one parameter at a time and then leave this programming mode. Therefore, each of
the parameters must be programmed separately. Refer to the “Parameter Defaults” section
earlier in this chapter for the factory defined default value of each programming parameter.
Host Tone Control
When a host terminal is used, this parameter determines what device controls the tone.
Scanning the
Hex 4 tag enables this option and the host terminal controls the tone. Scanning
the Hex 3 tag disables this option.
Enable/Disable Voice Messages
The 7893 uses voice messages for diagnostics, and clerk messages. If voice messages are
enabled, the messages are heard at the appropriate time; if they are disabled, the beep tones are
heard instead. To enable or disable voice messages, scan the following sequence of
programming tags. These tags must be the first tags scanned after applying power to the unit.
All Voice Messages Off/On

Program Mode

Hex 3

Hex 2

Hex D

Save and Reset