NCR RealPOS, User Manual

Page: 82 / 187

5-36 Chapter 5: Programming
Scans Required
This parameter sets the number of scans required to read a Code 128 bar code. Increasing the
number of scans can improve reading nominal bar codes. There are four settings: 1 scan, 2
scans, 3 scans, and 4 scans. The default is 1 scan. Set this parameter by scanning the
appropriate Hex tag (
Hex 1 to Hex 4) .
Overlap Characters
This parameter sets the minimum number of characters which each segment must contain
when tag stitching is done. There are four settings: 1 overlap character
(Hex 1) , 2 overlap
characters (Hex 2) (default), 3 overlap characters (Hex 3) , and 4 overlap characters
(Hex 4) . Set this parameter by scanning the appropriate Hex tag ( Hex 1 to Hex 4 ).
Minimum Segment Size
This parameter sets the minimum number of characters which each segment must contain
when tag stitching is done. Set this parameter by scanning the appropriate Hex tag (
Hex 2 to
Hex 9 ). The default is
Hex 4 .
Bar Codes–5
24952
GS1 DataBar Enable
Scans Required
On GS1 DataBar 14
B
A
Disable
0
Enable
GS1 DataBar 14
Only
1
1 Scan
1
2 Scans
2
3 Scans
3
4 Scans
4
1 8
Your Program
Bar Codes - 5 GS1 DataBar
Enable
A
Enable
GS1 DataBar E
Only
2
Enable
GS1 DataBar 14
& GS1 DataBar E
3
Scans Required
On GS1 DataBar E
C
1 Scan
1
2 Scans
2
3 Scans
3
4 Scans
4
UCC-128 Emulation
Mode
D
Normal Mode
0
UCC-128
Emulation Mode
1
B
Scans Required
On GS1 DataBar 14
C
Scans Required
On GS1 DataBar E
D
UCC-128
Emulation Mode
The Bar Codes 5 programming mode contains programming parameters for GS1 DataBar bar
codes. Refer to the “Parameter Defaults” section earlier in this chapter for the factory defined
default value of each programming parameter.