NCR 7460, User Manual

Page: 122 / 153

4-6 Chapter 4: Operating System Recovery
Completing the OS Installation (WinNT)
The system automatically reboots when the image recovery is complete
and starts the software installation. This installation also installs most
of the additional software and drivers that are included in the disk
image. Complete the installation as follows.
1.
After the terminal reboots, it will perform a disk check and then
continue with the Windows NT installation.
2. Enter the User Name and Organization.
3. Enter the Computer Name for the client.
4. Enter the Administrator’s Account Password (optional)
5. When prompted, press Finish to reboot the client.
6. Log in when prompted.
7. Press Next at the Found New Hardware wizard.
8. Open the Control Panel and run the MicroTouch screen calibration.
Completing the OS Installation (Win98)
The system automatically reboots when the image recovery is complete
and starts the software installation. This installation also installs most
of the additional software and drivers that are included in the disk
image. Complete the installation as follows.
1.
When the terminal boots it enters the Windows setup routine.
Note: When installing Win98 on terminals with early processor
boards (7460-22xx) there are few differences in the procedure as
follows:
a) The terminal starts the Add New Hardware Wizard .
b) For each device found, permit Windows to search for new
drivers (take defaults).
c) After each driver is installed you are asked to reboot. Answer
No
.