NCR 7158, Owner'S Manual

Page: 162 / 314

7-34 Chapter 7: Programming Guide
Select Cut Mode and Cut Paper
ASCII : GS V m GS V m n
Hexadecimal : 1D 56 m 1D 56 m n
Decimal: 29 86 m 29 86 m n
Value of m : Selects the mode as shown in the table
Value of n : Determines cutting position only if m is 65 or 66.
M Feed and Cut Mode
0, 48 Full cut (no extra feed). Partial cut on the 7158.
1, 49 Partial cut (no extra feed).
65 Feeds paper to cutting po ( n times vertical motion unit),
and cuts the paper completely.
66 Feeds paper to cutting po ( n times vertical motion unit),
and performs a partial cut.
Range of m : 0, 48; 1, 49
65, 66 (when used with n )
Range of n : 0 - 255
Default of n : 0
Default of m : 0
Selects a mode for cutting paper and cuts the paper. There are two
formats for this command, one requiring one parameter
m , the other
requiring two parameters m and n . The format is indicated by the
parameter m.
Formulas: n times the vertical motion unit is used to determine the
cutting position to which the paper is fed.
Exceptions:
If m is out of the specified range, the command is ignored.