NCR 5966, User Manual

Page: 40 / 54

6-6 Chapter 6: Touch Screen Calibration - Linux
3. Place a stylus in the center of the flashing target in the lower left-hand corner of the screen
and hold it until it beeps.
Note:
For best results, a stylus should be used to calibrate the screen rather than your
finger. Not all operators use the same touching techniques and can result in poor
calibration on terminals that have multiple operators.
24913
Toolkit Calibration
Please Touch The Calibration Symbol (ESC to Abort)
4. Repeat this procedure for the other three targets.
5. Select
OK
to continue.
6. Test the calibration by moving the stylus around on the screen and verifying that the cursor
follows it. Also, touch all 4 Corners and verify that the cursor moves deeply into the
corners.
7. If you are satisfied with the calibration results select
OK
to exit the TouchKit Utility.