Version 20.08.2020
HW: CAM(V100)/(V20)
RL4-MIB92
P
a
g
e
11
2.2.1.
Connection – factory head-unit
Disconnect the female 4pin HSD connector of the vehicle harness at the
Rear-side of the head-unit and connect it to the interface’s male 4pin HSD connector „To LCD“.
Note: If required, the marked lugs of the female 4pin HSD connector
have to be cut off! Further, the colour of the female 4pin HSD
connector may vary between
pink
and
grey
, depending on the
installed monitor.
Connect the female HSD+2 connector of the enclosed 4pin HSD picture signal cable to the
video-interface’s male HSD+2 connector “HU IN”.
Connect the female 4pin HSD connector of the enclosed 4pin HSD picture signal cable to the
previously become free male 4pin HSD connector of the
head-unit (colours may vary!).
Remove the female Quadlock connector of the
vehicle harness from the rear of the head-unit
and
connect the previously clipped out white
female 12pin connector (see graphic) to the male
12pin connector of the enclosed PNP harness.
Clip in the female 12pin connector of the PNP harness in the previously become free position
of the female Quadlock connector, before finishing the Quadlock reconnection at the rear of
the head-unit.