Navionics Raychart 425, Owner'S Handbook Manual

Page: 84 / 114

5-2 Raychart 425 Chartplotter
• Raytheon specified cables are used at all times. Cutting and rejoining
these cables can compromise EMC performance and so must be
avoided unless doing so is detailed in the installation instructions.
• If a suppression ferrite is attached to a cable, this ferrite should not be
removed. If the ferrite needs to be removed during installation it must
be reassembled in the same position.
Suppression Ferrites
Figure 5-1 shows typical cable suppression ferrites fitted to Raytheon
equipment. Always use the ferrites supplied by Raytheon.
Figure 5-1: Typical Suppression Ferrites
Connections to Other Equipment
If your Raytheon equipment is to be connected to other equipment using
a cable not supplied by Raytheon, a suppression ferrite MUST always be
fitted to the cable close to the Raytheon unit.
5.2 Unpacking and Inspecting the Components
Unpack your Raychart 425 Chartplotter carefully. Retain the carton and
packing materials in the event that you need to return the unit for service.
Referring to Table 5-1 , check that you have all the correct system
components.
Table 5-1:System Parts and Accessories
Item Part #
RC425 System comprising: E32032
RC425 Chartplotter R38064
Raystar 120GPS Receiver E32026
RC425 Accessories:
Sun Cover E35004
D3548-2