1
Nautilus NS700X
#
component
Qty
36 Pulley Bracket
1
50 Guide Rod Holder
2
51 Guide Rod
4
52 Top Weight
2
53 Selector Stem
2
55 Weight Stack Bottom Plate
2
56 Weight Stack Bumper
4
66 Weight Plate
38
86 Cap Head Allen Screw
1/4” x 1”L with thread lock
4
94 1/2” Flat Washer
1
96 1/2” Lock Nut
1
107 Weight Selector Pin
2
Step 8 Components:
Procedure:
a.
Slide Weight Stack Cushion (56) on two Guide Rods (51) allowing approximately 3” of Guide
Rod showing below the Weight Stack Cushion. Insert Guide Rods (51) into the holes in the
Rear Base Frame (1) as shown.
B.
Slide Weight Stack Bottom Plate (55) on top of Weight Stack Cushions (56).
c
. Place nineteen Weight Plates (66) and the Selector Rod/Top Plate Assembly (52 & 53) on the
Guide Rods (51) as shown. Install Weight Plates (66) so that the selector pin hole faces for
ward and is located on the bottom of the plate. Install the Selector Rod/Top Plate Assembly
(52 & 53) so that the head of the bolt is facing forward. This gym is supplied with individual
weight plate numbering decals that should be applied to the gym after the
weight stack is assembled.
D.
Slide Guide Rod Holder (50) on the top of the Guide Rods (51) and attach the Guide Rod Holder
(50) to the Rear Top Frame (2) using the hardware shown. Tighten hardware securely.
e.
Place Weight Selector Pin (107) in the bottom weight plate.
f
. Repeat Steps A-E for the second weight stack.
G
. Attach Pulley Bracket (36) to Rear Top Frame (2) using the hardware shown. Do not tighten
hardware.
ASSEmBLY
STEP 8