Nautilus Be strong NS 700X, Assembly Manual

Page: 16 / 26

1
# component Qty
58 4 1/2” Pulley 4
62 Cable Retaining Bracket 1
70 Cable #2 - High/Low Pulley Cable
356”L 1
79 Hex Bolt - 3/8” x 3”L 1
82 Hex Bolt - 3/8” x 2”L 2
84 Hex Bolt - 3/8” x 1 1/2”L
with thread lock 1
95 3/8” Flat Washer 7
97 3/8” Lock Nut 3
101 Pulley Spacer 1/2”L 2
Step 9 Components: Procedure:
a.
Remove the Ball, Washer, and U-Bracket from one side of Cable #2 (70).
B
. Route Cable #2 (70) through the Pulleys in the left Swivel Arm as shown. Continue to route
Cable around the two pulleys connected to the Rear Base Frame and then around the pulleys
located in the Rear Top Frame as shown.
c.
Loop Cable #2 (70) around a 4 1/2” Pulley (58) and attach pulley to the Top Weight Pulley
Housing (63) using the hardware shown
in detail A. Tighten hardware securely. Attach the Top Weight Pulley Housing (63) to the
Selector Rod/Top Weight Assembly (52 & 53). Do not tighten hardware.
D.
Loop Cable #2 (70) over a 4 1/2” Pulley (58) and attach pulley to the Rear Top Frame using the
hardware shown. Loop cable around a 4 1/2” Pulley (58) and attach pulley to the Rear Top
Frame using the Cable Retaining Bracket (62) and the hardware shown. Tighten hardware
securely.
e.
Route Cable #2 (70) through the top tube of the Rear Top Frame making sure that the cable is
above the bolts. Remove bolt if necessary Loop Cable around a 4 1/2” Pulley (58) and attach
pulley using the hardware shown in detail B. Tighten hardware securely.
f
. Route Cable #2 (70) around the pulley located on the Hi/Low Pulley Adjuster and continue to
route cable through the pulleys in the right swivel arm as shown.
G
. Re-Install the Ball, Washer, and U-bracket to Cable #2 (70).
ASSEmBLY
STEP 9