Nautilus Hyosung MoniMax 5600, Operator'S Manual

Page: 92 / 127

MoniMax 5600 6. Appendix
6 - 22
Error Code Cause Handling
20807 Receipt paper runs out of after printing
1.Replenish receipt paper in paper charger
2.Check the status of Near End sensor and its
connctor
20808
It is detected that paper is not properly
cut while operating
1.Check the Cutter module
2.Check if printer head lever is properly close
20809
Black mark is not properly detected in
receipt paper after printing
1.Check the status of Black mark sensor
2.Check if Dip switch # 6 is correctly set
(Dip switch # 6 is set by On in case of not using
Black mark)
2080A
The size of image print data is abnormal
while printing image
1.Check the AP version and initialize
97200
Failed to communicate with Receipt
printer when connected to SP open
1.Check if communication cable or com port is not
connected
2DN00
Failed to connect communication
between Receipt printer and SP
1.Check if communication cable or com port is not
connected
2080F
The firmware crashed
1. Check whether the dip switch #1 is set to “ON”
position
2. Update the firmware
2080B Margin setting error
1. Check whether the default registry setting is
changed
2. Reset the PTR SP
2080C Paper jammed at the exit of the slot 1. Remove the jammed paper
2080D Paper jammed in the path 1. Remove the jammed paper
97201
Hardware error occurred before
executing command
1. Reset the PTR SP