WARNING
Ensure the main ac power source for the transmitter system is disabled or locked out
before proceeding. If this is not observed, voltages that are fatal will be present.
NX200 Main-Standby Transmitter System Installation and Operation Manual
Page 2-59 (2-60 Blank)
Section 2 Preparation for Use and Installation
Issue 0.3
TEST LOAD INTERLOCK
: Provides an interlock for the test load. If the test load
interlock is open, the transmitter routed to the test load is interlocked off. Install a
suitable length of shielded cable between terminals TB2-7 (core) and TB2-8 (shield)
of the control/monitor assembly and the test load's interlock connection (see para.
2.3.7 for details on the test load).
XMTR A INTERLOCK
: Provides an interlock for the NX200 Transmitter (transmitter A).
If a system interlock or the test load interlock is open, or if the RF contactor has not
completed a transfer, transmitter A is interlocked off. Install a suitable length of 2-
conductor shielded cable (WE32) between terminals TB1-1 and TB1-2 of the
control/monitor assembly and transmitter A's interlock circuit (A11A1J6, see the
NX200 Transmitter manual for details).
XMTR B INTERLOCK
: Provides an interlock for the existing on-site transmitter
(transmitter B). If a system interlock or the test load interlock is open, or if the RF
contactor has not completed a transfer, transmitter B is interlocked off. Install a
suitable length of 2-conductor shielded cable (WE32) between terminals TB3-1 and
TB3-2 of the control/monitor assembly and transmitter B's interlock circuit (see the
transmitter's instruction manual for details).
XMTR A ALARM
: Provides a means to audibly monitor faults in transmitter A. Install a
suitable length of shielded cable between terminals TB1-3 (core) and TB1-4 (shield)
of the control/monitor assembly and pins 2 (core) and 1 (shield) of J5 of transmitter
A's remote interface PWB (A11A4).
If the
MUTE
toggle switch on the control/monitor
assembly's front panel (see Figure 3) is not set o
MUTE
, you will hear an audible
alarm when a fault occurs on transmitter A. If the toggle switch is not set to
MUTE
,
the audible alarm will be disabled.
Summary of Contents for NX200
