Page 2-2
NX200 Main-Standby Transmitter System Instruction Manual
Issue 0.3
Section 2 Preparation for Use and Installation
Table 2-1:
Recommended Tools, Equipment and Resources Required for Installation
Item/Resource Application
Forklift, 2000 kg
(4500 lb) capable
Mechanical assistance for moving heavy system crates; positioning heavy
components such as NX200 transmitter, transformers, ATU, soda load, dry cooler.
Skyjack, 250 kg
(550 lb) capable
Mechanical assistance for lifting elevated items into place such as cable tray,
transmission line, ventilation ducts, 4-port switch, IMU, etc.
Licensed
electrician
To safely plan and install ac wiring and cable tray system. Schedule accordingly.
Licensed
plumber
To plan and install plumbing between the soda load and dry cooler. See Soda Load
Kit - Pre-installation Considerations and Installation Instructions for more
information. Schedule accordingly.
Licensed
ventilation
technician
To plan and install the ventilation system that moves the exhaust air from the
transmitter output to the transmitter room or outside of the building. See Ventilation
Kit - Pre-installation Considerations and Installation Instructions for more
information. Schedule accordingly.
Pipe threader
To thread any pipe sections provided with the Plumbing Kit.
Support
Structures
The end user must provide a means to support various system components,
including the impedance matching unit (IMU), 4-port switch, all ventilation ducting,
all coaxial transmission line and all ac cable tray sections. It is the responsibility of
the end user to ensure these floor-mounted support structures do not infringe on the
clearance requirements of the transmitter components that are installed on the floor
of the transmitter building.
Pipe cutters
To trim the inner and outer conductors of 6-1/8 inch RF coaxial hardline.
Deburring tool
and Scotch
Bright pads
To clean up the cut ends of RF coaxial hardline.
Standard hand
tools
Miscellaneous tool kit including various screwdrivers (Phillips, flat, etc.), nutdrivers,
metric wrench set, pliers, wire-cutters, etc.
Summary of Contents for NX200
