Nautel GV5, Operation & Maintenance Manual, Page: 213 / 251

GV5/GV3.5 OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
PAGE 3.2.196 VERSION 0.2 2014-07-23
Enabling and Operating the Orban Audio Processor
This section describes how to configure, enable and operate the optional Orban audio processor after it
is installed in your transmitter. You can interface with audio processor functionality using the
transmitter’s local (or remote) AUI or controller UI. The extent of the features available depends on
which interface is used.
 Configuring the Transmitter for the Orban Audio Processor - see page 3.2.197
 Enabling the Orban Audio Processor for Preset Selection - see page 3.2.199
 Selecting an Orban Audio Processor Preset - see page 3.2.202
NOTE
: Using the Orban Inside option requires the installation of an Orban audio processor card in your
transmitter. If you had a pre-existing transmitter when you received your Orban Inside kit, verify that
the Orban card has been installed in the transmitter according to the Orban Inside Quick Guide
(QG12001), provided with the Orban Inside kit. Refer to the Pre-installation and Installation Manuals
for information on purchasing and installing this option.
NOTE
: This section contains frequent reference to Orban's Optimod-FM 5500 Digital Audio Processor
Operating Manual (see the link below). The equipment covered in the 5500 manual uses the same
Orban audio processor as in your transmitter. The 5500 manual provides detailed information on the
audio processor's functionality. If a discrepancy exists between the operational instructions in the
Orban manual and this document, the latter shall prevail as this document is specific to operation with
an GV5/GV3.5 transmitter. View the Orban Optimod-FM 5500 Digital Audio Processor Operating
Manual online at:
ftp://ftp.orban.com/5500/Documentation/
(the version number referenced in this link is controlled by a third party and is subject to change without notice)