Nautel GV5, Operation & Maintenance Manual, Page: 194 / 251

GV5/GV3.5 OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
VERSION 0.2 2014-07-23 PAGE 3.2.177
Select Output Channel - AUI
You can configure digital outputs 1 through 16 to monitor a variety of alarm and status outputs. Press
the existing
Channel
bar to display the
Select a remote
window (see Figure 3.2.152 ). From this
window, select one of the channels, then click
OK
to accept:

Not Assigned
. No alarm or status parameter is monitored.

Local/Remote
. The active logic level indicates the transmitter is in local control. The inactive
logic level indicates the transmitter is in remote control.

RF On/Off
. The active logic level indicates the transmitter’s RF power stage is on (enabled).
The inactive logic level indicates the transmitter’s RF power stage is off.

Preset Status
(1-3 default). The active preset’s output will be indicated by a logic low. The
remaining, non-active preset outputs will be open collector.

Active Exciter
. The active exciter’s output will be indicated by a logic low. The other, non-
active exciter output (as applicable), will be open collector.

Auto Changeover Enabled
. The active logic level indicates that auto changeover is enabled.
The inactive logic level indicates that auto changeover is disabled.

Various Alarms
. The active logic level indicates that the selected alarm is occurring. Any
transmitter alarm can be selected as a digital output. Refer to the GV5/GV3.5 Troubleshooting
Manual for a description of each alarm.
Figure 3.2.152: Select a Remote (output) window