Nautel Exporter Plus, Technical Instruction Manual

Page: 40 / 186

Exporter Plus Technical Instruction Manual Quick setup procedure
Page 6-2 Issue 1.0 2020-05-05
Starting the Exporter Plus
Prior to starting this procedure, ensure that the
IBOC
carriers cannot be broadcast, either by
muting the exciter, or by disconnecting the LAN connection from the Exporter Plus.
1. Turn on an audio processor (or audio processors) and verify that the audio is OK
2. Turn on the Exporter Plus using the front panel on/off switch.
The system will start up (for about 35 seconds). During initialization the
Status
LED
on the left-hand side of the Exporter Plus’ UI (see Figure 6.1 ) will be red and the other
three LEDs will be amber. The LEDs will then flash for about 10 seconds before
settling on their actual status.
Figure 6.1: Exporter Plus UI
Note: Refer to Section 8, “Operating” on page 8-1 for a complete hierarchy of all user
interface (UI) menu options as well as more detailed information on any of the user
interface pages referenced in this section.
Navigational
Buttons
LCD Display
LEDs
Cursor