![background image](http://html1.mh-extra.com/html/national-instruments/scxi-1314t/scxi-1314t_installation-manual_3503957004.webp)
SCXI-1314T TEDS Bridge Sensor Terminal Block
4
ni.com
To change shunt resistors, complete the following steps, referring to
Figures 1 and 2 as necessary:
1.
Unscrew the top cover screws and remove the top cover.
Figure 1.
SCXI-1314T Parts Locator Diagram
2.
Use long-nose pliers to carefully remove the socketed 100 k
Ω
precision resistors.
Note
To avoid damaging the precision resistors, pull the leads directly, alternating the
force back and forth rather than pulling the resistor itself.
3.
Use wire cutters to shorten the new resistor leads to 6.4 mm (0.25 in.).
1
Top Cover Screws
2
Top Cover
3
RJ-50 Connector
4
Thumbscrew
1
2
3
4