National Instruments SCXI-1141, Calibration Procedure

Page: 14 / 20

SCXI-1141/1142/1143 Calibration Procedure 14 ni.com
3. Remove the side plate of the SCXI chassis.
4. Install the module into slot 4 of the SCXI chassis.
Figure 3. Side Plate Removal and Module Installation
5. Read the Test Conditions section in this document.
6. Ensure that the E Series DAQ device is connected to the
SCXI-1141/1142/1143.
7. Call
SCXI_Set_Gain
to configure the module to a gain value of 1.
Set the following parameters:
• SCXIchassisID —The device number assigned by MAX
• moduleSlot —4
• moduleChan —0
• gain —1
8. Call
SCXI_Configure_Filter
to enable the filter bypass. Set the
following parameters:
• SCXIchassisID —The value configured in MAX
• moduleSlot —40
• channel —0
1 Thumbscrews 2 Slot 4 3 Side Plate
®
2
3
M
AIN
FR
AM
E
SC
XI
NA
TIO
NA
L
INS
TR
UME
NT
S
1