National Instruments RMX-400 Series, Programming Manual

Page: 22 / 181

RMX-4000 Series Programming Manual
22
C
OMMAND DETAILS
The Command Details chapter describes the
detailed syntax, equivalent panel operation, and
example for each command. For the list of all
commands, refer to page 14. Before programming
the RMX-400x electronic load, become familiar
with the Status registers, detailed on page 173.
Common Commands ............................... 24
Abort Subsystem ..................................... 32
Channel Subsystem ................................. 33
CONFIGURE Subsystem ........................... 38
Ut ility Subsystem .................................... 51
Current Subsystem .................................. 57
FETCH Subsystem ................................... 72
LOAD Subsystem ..................................... 77
Measure Subsystem ................................. 82
MODE Subsystem .................................... 87
OCP Test Automat ion Commands ............ 89
Program Subsystem ................................. 97
Resistance Subsystem ............................ 107
RUN Subsystem ..................................... 119
SHOW Subsystem .................................. 120
SPECIFICATION Subsystem .................... 122
STATUS Subsystem ............................... 126
Voltage Subsystem ................................ 135
Power Subsystem .................................. 144
SYSTEM Subsystem ............................... 150
............................................................. 151