User Guide
QuickSyn Frequency Synthesizer
35 of 44
Start Sweep
The Start Sweep button under the Power Sweep
Settings area of the Sweep Mode panel is used to execute power
sweeps after parameters are set.
Stop Sweep
The red Stop Sweep button under the Power Sweep
Settings area of the Sweep Mode panel is used to halt power
sweeps.
The List Mode panel, as shown in Figure 38, is accessible by
selecting the List Mode tab located in the upper-left corner of the
Main Control panel. The List Mode panel allows the user to setup
and execute a list of triggered sequences of Synthesizer states.
Step 5-4 Review the List Mode Panel
Figure 38
List Mode Panel
NOTE
When exiting the Sweep Mode panel, a reset command is issued and the Synthesizer
returns to its last saved state.
