12
|
ni.com
|
NI High-Speed Digitizers Getting Started Guide
Panel Mounting
To mount the USB-513x to a board or panel, complete the following steps while referring to
Figure 9.
Figure 9.
Mounting the USB-513
x
on a Panel
Note
Do not apply the rubber feet to the USB-513x when panel mounting the
device.
Note
Apply strain relief, as described in the
USB Cable Strain Relief
section,
before
panel mounting the USB-513x.
1.
Download and print the panel mounting template PDF attached in the KnowledgeBase
document,
USB-4065/5132/5133/6509 Panel Mounting Template
. Go to
ni.com/info
and enter the Info Code
rd3233
to locate the KnowledgeBase document.
2.
Using the template, mark the bottom point and top point on the panel. The points will be
162 mm (6.375 in.) apart.
3.
Remove the USB cable from the connector on the USB-513x.
4.
Screw a #8 or M4 screw into the bottom point on the panel.
5.
Set the USB-513x on the screw by fitting it into the bottom screw notch on the underside
of the USB-513x.
6.
Screw a #8 or M4 screw through the USB-513x top screw hole into the panel.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com