National Instruments Graphical User Interface Ultiboard, User Manual, Page: 254 / 281

Appendix A Menus and Commands
© National Instruments Corporation A-13 NI Ultiboard User Manual
Place»Keep-in/Keep-out Area
Use to define a polygon to restrict elements from either exiting or entering
the area. Refer to the
Working with Keep-in/Keep-out Areas section of
Chapter 5, Working with Traces and Copper , for more information.
Place»Group Array Box
Use to place parts in a grid array. Refer to the Placing a Group Array Box
section of Chapter 4, Working with Parts , for more information.
Place»Pins
Used during In-Place Editing of a part to place a footprint. Refer to the
Editing a Placed Part (In-Place Edit) section of Chapter 4, Working with
Parts , for more information.
Place»Via
Use to place a via. Refer to the Working with Vias section of Chapter 5,
Working with Traces and Copper , for more information.
Place»Test Point
Use to place a test point. Refer to the Working with Test Points section of
Chapter 4, Working with Parts , for more information.
Place»Jumper
Use to place a jumper. Refer to the Working with Jumpers section of
Chapter 4, Working with Parts , for more information.
Place»Net Bridge
Places a net bridge on the design. Refer to the Net Bridges section of
Chapter 5, Working with Traces and Copper , for more information.
Place»Hole
Places a hole on the workspace. Refer to the Placing Holes section of
Chapter 4, Working with Parts , for more information.