©
National Instruments Corporation
3
CA-1000
Note
The CB-68LPR and SCB-68 attach directly to the wall of the enclosure. The SCB-68
accommodates only a 68-pin external connection through the rear of the enclosure.
You must remove the SCB-68 circuit board from its original enclosure before installing it
in the CA-1000 enclosure.
❑
One or more I/O panelettes
You do not need to configure your CA-1000 enclosure or its components
other than to decide where to put your signal connections (both input and
output in some cases). To configure your internal accessory, see the manual
for that accessory.
Installing the CA-1000 Components
The CA-1000 system consists of four components:
•
CA-1000 enclosure
•
Internal accessory
•
Internal cable assembly (not required for all internal accessories)
•
I/O panelettes
By choosing a specific combination of components, you can customize the
CA-1000 for many applications.
Summary of Contents for CA-1000
Page 1: ...SC 2042 RTD...