CA-1000
10
ni.com
Refer to Figure 6 and use the following steps to install the SCB-68 into the
CA-1000 enclosure:
1.
Tighten the 1/2 in. long nylon 4-40 female-to-female standoffs on the
pre-installed threaded studs as indicated.
2.
Install the 68-pin filler panel on the 68-pin connector with
two M2.5 jacksocket screws provided with the SCB-68.
3.
Install the 68-pin filler panel in the enclosure with two 4-40
×
3/16 in.
flathead Phillips-head screws provided with the CA-1000. This
positions the SCB-68 over two of the female-to-female standoffs.
Note
See
later in this guide and Figure 7 for details on installing
the 68-pin filler panel.
4.
Insert and tighten the two 4-40 panhead mounting screws provided
with the SCB-68.
Figure 6.
Installing the SCB-68
1
Pre-installed Threaded Studs
2
Standoffs
3
4-40 Screws
4
SCB-68
1
2
3
4
Summary of Contents for CA-1000
Page 1: ...SC 2042 RTD...
