©
National Instruments Corporation
15
CA-1000
Rubber Feet
Each CA-1000 enclosure comes with a set of four rubber feet and four
screws as shown in Figure 10. Use the following steps to install the rubber
feet:
1.
Place a 4-40 panhead shoulder screw with a 0.08 in. shoulder length
and a 0.125 in. thread length through the center of each rubber foot.
2.
Screw all four rubber feet to the bottom of the CA-1000 enclosure.
Figure 10.
Installing Rubber Feet
1
4-40 Panhead Shoulder Screws
2
Rubber Feet
1
2
1
2
Summary of Contents for CA-1000
Page 1: ...SC 2042 RTD...
