![background image](http://html1.mh-extra.com/html/national-instruments/ca-1000/ca-1000_installation-manual_3396790014.webp)
©
National Instruments Corporation
13
CA-1000
Refer to Figure 8 and use the following steps to install any of the
I/O panelettes:
1.
Choose one of the I/O panelettes to install.
2.
Place the lower edge of the I/O panelette in the groove at the bottom
of the enclosure opening.
3.
Tilt the I/O panelette top back into the enclosure.
4.
Secure the I/O panelette with either one, two, or three of the
M2.5
×
6 panhead screws (depending on the type of I/O panelette)
that are included with the panelette.
5.
Repeat steps 1 through 4 until you have installed all your functional
I/O panelettes.
6.
Install a blank I/O panelette in any unused panelette opening.
Note
You must remove the pre-installed rear panel prior to installing any I/O panelettes
on the rear of the CA-1000.
Figure 8.
Installing an I/O Panelette
1
Thermocouple I/O Panelette
2
M2.5
×
6 Screw
3
BNC I/O Panelette
4
Strain-Relief I/O Panelette
5
D-Sub I/O Panelette
6
Dual D-Sub I/O Panelette
7
Blank I/O Panelette
1
2
3
4
5
6
7
Summary of Contents for CA-1000
Page 1: ...SC 2042 RTD...