National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-4000 / F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2015 National Cycle, Inc.
Page 9 of 12
10-118032-000 05/15
FRONT OF VEHICLE
18
19
17
20
3
Illustration C
Figure 19
Figure 20
Figure 21
Perspective from below top frame
looking up, or inside of right
frame.
WINDSHIELD INSTALLATION
1. Snap the Wraparound Clamps (17) to the frame of
the vehicle. Orient the top clamps facing down and male
half (with embossed part number) toward the front of the
vehicle.
Figure 18 and Illustration B
Read these helpful tips for a smooth installation:
Place fasteners within reach of assembling
clamps.
Note the hex shape of Retainer Pin (18), and
male Clamp (17) half.
Apply tape to lower area of grab handle to
prevent drill from scratching handle during
clamp installation.
Figure 19
While installing the windshield Clamps (17)
tuck Wire Harness between Clamp and
Windshield.
Figure 20
Place Spacing Washer (19) between Grommets
(3) and Clamps (17).
Start Machine Screws (20) but do not tighten.
The tabbed section of the Windshield should
be touching the hood of the vehicle.
2. Place Windshield on hood. Tuck Wire Harness
between Clamps and Windshield.
Figure 19 and 21
3. Using Screws (20) and Spacing Washers (19), install
Clamps (17), but do not fully tighten.
Figure 20 and Illustration C
(Phillips Screwdriver or Power Drill on low setting)
4. Check the alignment and position of the windshield
and make sure it is even and symmetrical.
5. Securely tighten the Machine Screws (20) in all Wrap-
around Clamps (17).
Illustration B
Figure 18
