WIRE HARNESS INSTALLATION-
ROCKER SWITCH TO DASH
1. Locate the section of Wire Harness (c) that terminates
in the Two-Way Rocker Switch. Temporarily remove the
Rocker Switch and thread the wiring under the hood to-
ward the hole you cut in the dash panel’s accessory bay
in Figure 2. Thread the Wire End (c) through the hole.
Figure 10
2. Move inside the vehicle and reattach the Two-Way
Rocker Switch to the two Nylon Pin Connectors (polarity
doesn’t matter) and then push the Rocker Switch into the
cutout.
Figure 11
3. Completed dash panel Rocker Switch should appear
as shown.
Figure 12
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-4000 / F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2015 National Cycle, Inc.
Page 6 of 12
10-118032-000 05/15
Figure 11
Figure 12
Figure 10
