PREPARE THE VEHICLE FOR WIRING
CUTTING THE PASSWAY 3/4” HOLE
1. Open the front hood.
2. On the hood of the vehicle behind the engine cover
on the driver’s side, measure a point 3" (7.6cm) from the
front of the body and 1" (25mm) from the frame cutout
on driver’s side (left) of vehicle. Mark that location. This
hole should be located near the Left Frame Bar.
Figure 3
3. Insert a step drill bit into your drill as shown (or 3/4
hole saw) and drill a 3/4” (19mm) hole in the body cover
at the location marked in figure 3.
Figure 4
MOUNT RESERVOIR/PUMP ASSEMBLY TO
BRACKET
1. Using a Slotted Screw (24), Washer (25) and Nut (26)
from Bag #1185 install the Reservoir (10) to the
mounting Bracket (23).
Figure 5 (Flat Blade Screwdriver and 3.8” Box
Wrench)
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-4000 / F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2015 National Cycle, Inc.
Page 4 of 12
10-118032-000 05/15
Figure 3
Figure 4
Figure 5
Image shows front hood open.
FRONT OF VEHICLE
