Battery Connections Black-
Negative, Red-Positive
Pump Switch for Wash
Mounts to Dash Inside Cab
Motor Connector and
Fluid Hose
Installs to Motor
Grommet, Seals
3/4’ Hole
Pump Connector and Fluid Hose
Installs to Fluid Reservoir/Pump
WIRE HARNESS
11 x1
b.
c
a
d.
e.
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-4000 / F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2015 National Cycle, Inc.
Page 3 of 12
10-118032-000 05/15
Figure 2
X
X
X
Figure 1
PREPARE THE VEHICLE FOR WIRING
REMOVE SEATS AND CENTER CONSOLE
1. Remove seats.
2. Remove center console.
Figure 1 (T27 Torx)
One of the 7 screws holding the center console is
different from the rest.
CUTTING THE PUMP SWITCH HOLE
The installation of the Pump Switch on this
vehicle is in the recessed area of dash panel
indicated by the X. Select your preferred location
for the switch. Use care when cutting hole, avoid
over cutting.
Figure 2
1. Disconnect the Pump Switch (c) from the main Wire
Harness. Check the size of Pump Switch against the lo-
cator bay. Scribe or draw a 17/32” x 1 1/8” (13.5mm x
28.5mm) guide in the desired location.
2. Using a drill, drill some holes in the plastic cover to
serve as starting holes for cutting. Then use your X-Acto
knife to cut out the cover’s face to the edges shown.
Figure 2 (Drill, X-Acto Knife)
INSTALLATION
Parts List, Wire Harness
