NATI BlueMAX 53542, Manual

Page: 13 / 18

“0“.
Normal procedure:
Let go of the throttle lever and wait until the
engine has changed to idling speed. Then set the
7.4 Fitting the shoulder strap
Important! Always use the shoulder strap when
(risk of injury).
1. Slip the shoulder strap over your shoulder.
2. Adjust the length of the shoulder strap so that
the strap attachment is at waist level.
7.5 Work practice
Practice all the work steps with the engine
equipment.
8. Working with the chainsaw
Preparations
To ensure that you can work safely, check the
following points before every use:
Condition of the chainsaw
Before you start your work, inspect the chainsaw
for damage to the housing, the chain and
the cutter bar. Never use a chainsaw which is
obviously damaged.
Oil container
Level of oil in the oil container: Both before and
during your work make sure that there is always
the chainsaw, never run the saw if there is no oil
in the system or if the oil drops below the „min“
mark.
minutes depending on the number of pauses in
cutting and the loads involved.
Chain
Tension of the chain, condition of the cutting
starter cable (Fig. 2/Item 13) until you feel it
begin to resist. Then tug sharply on the starter
cable 4 times. The equipment should start.
Important: Never allow the starter cable to
snap back. This may result in damage.
Once the engine has started, move the choke
lever immediately to “ “ and allow the
equipment to warm up for approx. 10 seconds.
Important: Since the throttle lever is secured,
the cutting tool starts to operate when the
engine is started.
Then release the throttle lever by actuating it
once.
6. If the engine does not start up, repeat steps
4-6 above.
Please note: If the engine does not start up even
after several attempts, read the section “Engine
troubleshooting“.
Please note: Always pull the starter cord out in
a straight line. If it is pulled out at an angle, then
friction will occur on the eyelet. As a result of this
friction, the cable will become frayed and will
wear away faster. Always hold the starter handle
when the cable retracts.
Never allow the cable to snap back when it has
been pulled out.
7.2 Starting with a warm engine
(The equipment has been idle for less than 15-20
min.)
1. Set the equipment down on a hard, level
surface.
2. Switch the On/Of switch to “I“.
3. Secure the throttle lever (in the same way as
described in “Starting with a cold engine“).
starter cable until you feel it start to resist.
Then tug sharply on the starter cable. The
equipment should start after 1-2 tugs. If the
equipment does not start after 6 pulls, repeat
steps 1 – 7 of the procedure for starting the
engine from cold.
Eme 7.3 rgency Stop procedure:
If it becomes necessary to stop the equipment
1-800-348-5004
feedback@natitools.com
13