22
NARVON
Lean the pin on its seat and push the push lever until it is
introduced to the tap
Note: Correctly install the components as
shown in the figure. The non-lubrication of
the cap may cause product leakage from
the tap.
7.6. Rinsing Cycle
Before starting up the machine you must run the rinse cycle.
Proceed as follows:
1. Fill the bowl with clean water.
2. Turn on the machine for 5 minutes in the (agitation) mode
only.
3. Turn off the machine and empty the tank by opening the
tap.
7.7. Cleaning the drip tray
The drip tray should be emptied and cleaned daily.
Note: All of the drip trays present in the machine
should be cleaned. The drip tray should be
emptied and cleaned every time the red float
installed in the grid rises into view.
Carefully unhook the drip tray from the machine.
Wash the drip tray and grid in lukewarm water and dry.
Reposition the grid on top of the tray and hook back into
place on the machine.
7.8. Lid Maintenance
Maintenance of the lighted lid must be
performed by a specialized technician.
The operator is forbidden to disassemble any
lid component.
Components:
S: Cover
T: Bulb Holder
U: Bulb
V: Lid Top (upper part)
Z: Decal
X: Lid Bottom
Y: Cable with “male” Jack Plug
Fig. 42
Fig.43
Fig. 44
