NARGESA NOA60, Instruction Book

Page: 96 / 116

- A45 -
1. We put into order the different sections
We will use the different sections of the rollers depending on the tube size that we are going to emboss. To
assemble the
upper roller of 60mm we will proceed as follows:
2. We do a pre-assembly, without tightening the
bolts, paying special attention in aligning the slots
for the pin.
3. Place the pre-mounted roller on the upper axis
and tighten the bolts with the Allen key. 4. We remove the roller from the shaft and we
rotate it so that the front part is positioned behind
and then we put it in again.
5. Tighten the bolts with the Allen key.
4 5
6. We remove the roller from the shaft and we
rotate it so that the front part is positioned behind
and then we put it in again.
5 4