NARGESA NOA60, Instruction Book

Page: 17 / 116

- 18 -
EMBOSSING MACHINE NOA60
Once the manual operation mode has been chosen and the desired rollers fitted, we will proceed with the
machine adjustment:
- Using the Embossing Adjustment Wheel, raise the upper shaft as high as it will go. - Raise the upper
straightener roller as high as it will go. - Raise the upper exit guide.
- Lower the straightener rollers to their lowest position.
- Open the horizontal straighteners completely.
- Insert the bar of material you wish to emboss and check that there is no interference with the vertical and
horizontal straighteners.
- Then, with the aid of the adjustment wheel, lower the embossing roller to press on the para material. You
may have to lower the upper output guide to avoid interference with the roller.
- Once you feel pressure on the material, press the forward pedal for the machine to begin embossing.
- When the material comes out of the other end, observe the depth of the marking, if you want deeper
embossing, press the reverse pedal until the material is released from the roller.
- Use the Adjustment Wheel to make deeper markings and press the forward pedal again. Repeat this
action until the desired marking on the material is obtained.
- When the desired marking has been achieved, raise the lower straightener rollers until they touch the
material without force. Carry out the same operation with the upper roller and with the output guide.
- If, when embossed, you observe that the material is curved vertically, proceed to adjust the upper and
lower straighteners until the material comes out flat.
- If you observe a horizontal curve, adjust the horizontal straightener rollers until the material comes out
straight.
When all this has been done, the NARGESA NOA60 is ready for production in the Continuous/Automatic
operation mode.
NOTE: Never adjust the force of the embossing rollers when they are pressing on the material,
as this could damage the rollers.