NARGESA MP1400 CNC, Instruction Booklet

Page: 47 / 77

INSTRUCTIONS BOOK FOR PRESS BRAKE MP1400 CNC 46
8. SEMI AUTOMATIC MODE OF THE MACHINE
From the main menu of the PRESS BRAKE MP1400 CNC you can opt for this mode of operation. If you do
and then press to confirm your selection, the display information changes for new menu.
Out of all the options you have available, you can select the one that suits you better you need by using the
scroll arrows. However, in this case, we start by the first one of all so we can follow an order. Therefore,
hover over the 'Punches' option and press to confirm your choice.
8.1. Punches
Upon entering this menu, the information shown on the LCD graphic display changes completely. In this
case it appears the picture of the actual punch with the most relevant information from it on the right. There
are 50 punches among which you can go through. To do this, you have to press the keys . Each
press will go forward to the next punch, or back to the previous. To load it into memory press
8.2. Dies
The choice of diez on the Press brake manu allows you to view the 50 dies that are loaded into the memory
of the machine. In order to navigateit is necessary to proceed in the same way as the menu of the punches,
ie, using the keys.
>>>
OPERATION MODE SELECTION
Manual Mode
Semiautomatic Mode
Configuration Mode
>>>
SEMIAUTOMATIC MODE PRESS BRAKE
Punches
Dies
Editing Memory
Operating with Memory
List of Memory
PUNCH 1
Height = 135.1 mm
Angle = 90º
Radius = 0.0 mm
Max T/m = 100.0
PROMECAM System