Napoleon TQ285, User Instructions

Page: 5 / 32

www.napoleongrills.com
5
EN
Handle With Care
CAUTION!
Use care when handling or transporting your grill to prevent damage and misalignment
of internal components. Although this grill has been designed with mobility in mind, rough handling or
abuse will result in damage to internal components, preventing your grill from operating properly.
WARNING!
The dust cap should be in place when the propane cylinder is not in use to
prevent dirt and debris from entering.
WARNING!
Review instructions on propane cylinder prior to using. A dented or rusted
cylinder may be hazardous. Discard cylinder if rust particles or debris are in the connection
area of the propane cylinder.
General Information
This gas barbecue is certified under Canadian and American National Standards, CSA 1.18 - 2013 and
ANSI Z21.89 - 2013 respectively for outdoor gas grills and should be installed to conform to local codes. In
absence of local codes, install to the current CAN/CSA-B149.1 Propane Installation Code in Canada or to
the National Fuel Gas Code, ANSI Z223.1/NFPA 54 and ANSI/NFPA 58 in the United States.
Use only the pressure regulator provided with this barbecue. Replacement pressure regulators must
be supplied by or specified by the manufacturer. The regulator supplies a pressure of 11 inches water
column to the gas grill and has a female CGA#600 type fitting.
Cylinder Installation: 1 lb (.454kg) disposable cylinders to be used with this unit must be equipped with
a male CGA #600 type connection. This cylinder has a positive seating connection, which will not allow
gas flow until a positive seal has been achieved. To install the cylinder simply screw it into the regulator -
tighten hand tight.
WARNING!
Use cylinders that are marked “Propane Fuel” only.
WARNING!
Be careful not to cross thread when installing the cylinder. Do not use tools to
tighten the cylinder.
WARNING!
Do not operate the grill if the regulator shows signs of impact damage.