3.7 hard wiring installation
HARD WIRING CONNECTION
If it is necessary to hard wire this appliance, a qualified electrician must remove the cord connection, and wire the
appliance directly to the house hold wiring.
This appliance must be electrically connected and grounded in accordance with local codes, if hard wired. In the
absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the current
ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.
A.
Remove the cover plate from the right side
bottom of the appliance by removing the
3 screws
(Fig. 1)
.
B.
Remove the wire connectors from the
power cord. The power cord may
be discarded.
C.
Punch out the 7/8" (22.2mm) hole in the new cover plate (supplied)
(Fig. 2)
and install a box connector
through and into the junction box. Snap the box connector clamp onto the supply wires.
D.
Using the wire connectors, connect the ground green wires (G) and the common white wires (N)
together, and then the hot black wires (L)
(Fig. 3 and 4)
.
E.
Reinstall the cover plate using 3 screws
(Fig. 1)
.
Fig. 1
COVER PLATE
G
N
L
Fig. 2
7/8" (22.2mm)
Diameter
Fig. 3
Fig. 4
W415-2172 / B / 08.10.18
EN
16
installation
• Turn off the appliance completely and let cool before servicing. Only a qualified service person should service
and repair this electric appliance.
!
WARNING
