EN
W415-2172 / B / 08.10.18
17
4.0 finishing
• Power supply service must be completed prior to finishing to avoid reconstruction.
• Heat vents and air openings cannot be covered in any circumstances.
!
WARNING
4.1 mesh trim front installation
A.
Remove the 2 screws from the top of the appliance.
B.
Have 2 people lift the mesh trim up and away from the appliance, holding the mesh trim vertical - not flat -
while carrying. Place the mesh trim face down onto a soft, non-abrasive surface, being careful not to flex
the mesh trim.
C.
Bend the top tabs flat
(Fig. 1)
.
D.
Install the crystal embers (see "crystal ember installation" section).
E.
Install the mesh trim front by aligning with the pins on the appliance. Press the mesh trim in and down to
securely engage with the brackets. It must be fully engaged to ensure the touch display panel performs
properly.
F.
Secure the mesh trim front using the screws provided to the top of the appliance
(Fig. 2)
. If appliance is
fully recessed, this is not necessary.
Fig. 1
• The door latches are part of a safety system and must be properly engaged. Do not operate the appliance with
latches disengaged.
• Facing and/or finishing materials must not interfere with air flow through air openings, louvre openings,
operation of louvres or doors, or access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
!
WARNING
Fig. 2