SETTING UP THE GEAR LOFT
8. Once the tent is assembled, attach the pole clips to the poles.
9. If the tent side straps are too loose, tighten the straps.
Remember the straps should not be too tight.
10.
To install the gear loft, place each corner hook of the gear
into the loop located on the ceiling of the tent.
7. Insert the poles into the pole pockets in the following order:
A. Insert the LIGHT GREY POLE (side-to-side) into the grey
webbing pocket above the window
B. Insert the BLUE POLE (corner-to-corner) into the blue pole
pocket near the truck’s cab. Insert the other end into the blue
pole pocket by the tailgate. Repeat with the other blue pole
C. Insert the end of the SHORT GREEN POLE (rear cab) into the
grommet hole located on the tab near the side of the tent.
Repeat on the other side
D. Insert the LONG GREEN POLE (tailgate) into the green pole
pockets at the tailgate
E. Insert the BLACK POLE (inside) into the black pole pocket
(above door and rear cab access) inside the tent. Velcro the
pole to the tent using the Velcro tabs
B
B
C
C
B
B
D
D
A
A
E
E
SETTING UP THE RAINFLY
11. Locate the front of the rainfly that goes over the door (it will
have a Napier tag on the side). Place the rainfly over the tent
(front to back). You may require assistance due to the height
of the tent.
12. Attach the rainfly to the tent by securing the 6 strap clips
(2 per side and 2 at tailgate). Tighten the straps if necessary.
SETTING UP THE AWNING
NOTE, if you do not wish to use the awning, roll up the awning
and secure it with the toggles.
13. Assemble the awning poles (6) by unfolding each section.
Insert the top awning pole into the bottom pole which has
the plastic clasp (clasp must be open). Close the clasp once
you have the desired height of the pole.
14. Slide the NAVY BLUE POLES (inside awning) through the pole
sleeve in the roof of the awning. Insert the poles into the
pole pockets on each corner of the awning.
15. Place the pointed end of the bottom awning pole into the
grommet hole at the tailgate. Place the other end into the
grommet hole at the corner of the awning. Secure with strap.
Repeat for the other pole.
16. To secure the awning to the ground, insert 1-2 guide ropes
with ring around the top awning pole point and place the
awning cap over the point. Stake the other end to the ground
with a peg. Adjust the guide rope length.
NOTE, this step is not required for awning to function.
2017 Napier Outdoors
Rev. 09 11.04.16
3 of 7
