CAUTION
• Do not use candles, matches or open flames of any kind in or
near the tent
• Do not cook inside the tent
• Build campfires downwind and several meters away from the
tent. Be sure to fully extinguish fires before leaving a campsite
or before retiring for the night
• Exercise extreme caution when using fuel-powered lanterns or
heaters inside or around the tent. Use battery-operated
lanterns whenever possible
• Do not refuel lamps, heaters or stoves inside the tent
• Extinguish or turn off all lanterns before going to sleep
• Do not smoke inside the tent
• Do not store flammable liquids inside a tent
• NEVER run the vehicle engine when the tent is attached
• Do not install the tent when the temperature is below
0ºC/32ºF or when your vehicle is wet, it may cause damage
• Allow adequate ventilation inside the tent at all times
• Do not attempt to drive the vehicle with the tent attached
CAMPSITE SELECTION
• Select a smooth level campsite clear of rocks, branches and
other hard or sharp objects
• Park the vehicle in the chosen campsite. Turn off the engine
and apply the parking brake
TENT SETUP
For easier assembly
, set the tent up on the ground leaving step
2 - 4 until the end. Once the poles are inserted, lift the tent into
the truck bed and strap down.
1. Lower the truck’s tailgate.
2. Remove the tent from the tent bag and lay it flat in the bed of
the truck. Locate the front door and place this end at the
tailgate with the other end towards the cab.
3. Locate the tent side straps (3 per side). Loosely attach each
strap to the truck’s body.
4. Locate the tent tailgate straps (3). Slide the 3 straps with the
female clip between the truck box and the tailgate (you may
have to lift the tailgate to do so). Connect the male clip strap to
the corresponding strap with the female clip.
6. Insert the poles into the corresponding color sleeve in the
below order. Note, the poles may get stuck on the pole sleeves.
Do not force the pole, simply lead them through the sleeve.
Do not place the poles in the pole pockets at this time.
A. Slide the BLUE POLE diagonally, corner-to-corner through
the pole sleeves in the roof of the tent. Repeat for the other
blue pole
B. Insert the LIGHT GREY POLE into the corresponding grey
sleeve in the roof of the tent, from side-to-side. The blue
corner-to-corner poles should be below the gray pole
C. Slide the SHORT GREEN POLE into the pole sleeve at the
back of the tent, near the truck’s cab
D. Slide the LONG GREEN POLE into the pole sleeve at the
front (tailgate) of the tent
POLE
LOCATION
Blue Poles (A)
Corner-to-Corner
Light Grey Pole (B)
Side-to-Side
Green Short Pole (C)
Rear Cab
Green Long Pole (D)
Vestibule/Tailgate
5. Assemble the tent poles by unfolding each section.
A
A
C
C
A
A
D
D
B
B
2017 Napier Outdoors
Rev. 09 11.04.16
2 of 7
