6
2
WIRE THE G-BOX
CONNECT THE G-BOX TO ROUTER
1. Record the
ISEE-VCAM1
Security Code (bottom label, example: SC106763) which will
be needed in the subsequent registration steps:
2. Power-down existing network devices (i.e. Cable Modem, Router, etc.).
3. Connect the Cable or DSL Modem to the G-BOX WAN port.
4. Connect
ISEE-EOP-MOD200
to any
G-BOX LAN
port.
5. If necessary, you may connect existing PC to any available LAN port --OR--if customer
has a router, connect the router WAN port to any available LAN port.
5. Power Up all the devices. Several minutes may be required for the
DHCP sessions to take place.
IMPORTANT:
For installations on Cable Internet systems, power
down cable modem for 10 minutes, then power up the complete
system to allow ISP to synch with the MAC address of the G-BOX.
Go
to
VideoAlert.net Activation
on page 7.
Indica-
tor
Color
Solid
Flashing
Power
Green
Turns solid green
when power is
applied to device.
N/A
SYS
Green Normal Normal
WAN
Green
Connected and
linked to a Cable/
DSL Modem.
Receiving/
Sending data
LAN 1
to
LAN 4
Green
Turns green when
linked to a local
network.
Receiving/
Sending data
G-BOX LED INDICATORS
BROADBAND
MODEM
G-BOX
WAN
(INTERNET)
CUSTOMER'S
ROUTER
CUSTOMER'S
PC
)
If no router installed, connect PC
directly to the G-BOX LAN ports
WAN
LAN1
LAN2
LAN3
LAN4
Note:
G-BOX LAN Ports are auto-sensing. Customer's devices
or the ISEE-EOP-MOD200 may be plugged into any port
.
WAN
LAN1
LAN2
LAN3
LAN4
ISEE-EOP-MOD200
Note: If AC power-strips
are required due to un-
available AC outlets, non
surge protected or noise
filtered power-strips must
be used. Many AC power-
strips utilize internal surge
protection that may pre-
vent the EOP modules
from operating.
EOP module must
be plugged directly
into wall outlet
