NAPCO Gemini GEM-P3200, Installation Instructions Manual

Page: 3 / 68

L
NAPCO Security Systems
X
GEM-P3200 Installation Instructions
WI817F 10/05 Page 3
IMPORTANT NOTE
This manual supports the keypad programming of the GEM-P3200 control panel with the NAPCO "classic" GEM-
RP1CAe2, GEM-RP2ASe2, GEM-RP3DGTL and GEM-RP4RFC/GEM-RP4C keypads as well as the GEM-K1CA, GEM-
K2AS, GEM-K3DGTL, and GEM-K4RF/K4 "K Series" keypads. The new "K Series" models offer the new STAY and
AWAY buttons with simplified functionality, along with the new MENU and ENTER buttons.
While the instructions in this manual are depicted using the GEM-K1CA and GEM-K2AS keypads, the manual applies to
both the "classic" and the "K Series" keypads.
Program Mode is the same for both keypads-- only the button names have changed , as follows:
•
The
A
button and the
R
button operate identically (in Program Mode) for both keypads.
•
The
D
button and the
U
button operate identically (in Program Mode) for both keypads.
•
The button and the button operate identically (in Program Mode) for both keypads. The words
" NEXT/YES button" are used in this manual.
•
The button and the button operate identically (in Program Mode) for both keypads. The words
" PRIOR/NO button" are used in this manual.
For consistency, it is recommended that all keypads either be all "classic" or all "K Series"--both keypad
types should not be used in one alarm system.
IMPORTANT NOTICE
GEM-P3200 panel version 40 and higher requires the use of the following version keypads:
•
GEM-RP1CAe2 Version 8c, GEM-K1CA Version 8c
•
GEM-RP2ASe2, Version 6d, GEM-K2AS, Version 6d
•
GEM-RP3DGTL, Version 2e, GEM-K3DGTL, Version 2e
Upon entering program mode, the keypad display will flash the control panel firmware version, followed by the keypad firmware
version:
GEM-RP1CAe2: [308c], GEM-RP2ASe2: [306d], GEM-RP3DGTL: [302e]
GEM-K1CA: [308c], GEM-K2AS: [306d], GEM-K3DGTL: [302e]
Note: Typically, most versions of the GEM-P3200 control panel can be upgraded to the latest firmware by replacing the EPROM with
a newer version. The Firmware Version 30 EPROM should only be used in a Version 25 (or higher) PC board. The PC board ver-
sion (triangle number) is printed on a triangularly shaped sticker affixed to the GEM-P3200 circuit board.