NAPCO GEM-RP8LCD, Operating Manual

Page: 6 / 32

6
AR M I N G AW AY : S E T T I N G T H E AL AR M W H E N L E AV I N G
Z O N E S F A U L T E D
0 2 B A C K D O O R
BYPA SSED B Y P A S S E D
BYPA SSED 0 2 B A C K D O O R
Arming the System
1
Check the keypad for a SYSTEM READY message. The green STATUS light
must be on in order to arm . The window will display “SYSTEM READY”. If the
green light is off and “ZONES FAULTED” is displayed in the window, see below
“
Arming with a Faulted Zone ”.
2
Arm the system.
!
Enter your User Code and press
Q
.
!
Hold down
Q
for 2 seconds (with Easy Arming enabled).
The green STATUS light will turn off, the red ARMED light will light and the window
will display “PLEASE EXIT”, “XXX SECONDS” (where “XXX” represents the exit
time remaining, in 2-second steps). Note: If you enter a wrong code, the keypad
will display “INVALID ENTRY, TRY AGAIN”. Re-enter your code immediately.
3
Leave the premises . Leave through the exit door before exit time expires.
Arming with a Faulted Zone
If the green light is off and “FAULTED ZONES” is displayed in the window, a faulted
zone exists and the keypad will display the number and zone description of each
faulted zone. Note each problem zone and secure them by closing windows, doors,
etc. When all zones are secure, the green STATUS light will turn on and the window
will display “SYSTEM READY” or READY TO ARM”.
If you attempt to arm with a faulted zone, a 3-second tone will sound at the keypad.
“CAN’T ARM SYSTEM ...ZONE FAULTED”, will display in the window, indicating that
the faulted zone(s) must either be secured before the panel can be armed or the Zone
must be Selectively Bypassed. See next page, “
Selectively Bypassing Zones ”.
P L E A S E E X I T
0 3 0 S E C O N D S
I N V A L I D E N T R Y
T R Y A G A I N
S Y S T E M R E A D Y
C A N ’ T A R M S Y S T E M
. . . Z O N E F A U L T E D
0 2 B A C K D O O R
F A U L T E D Z O N E S