NAPCO GEM-RP8LCD, Operating Manual

Page: 11 / 32

11
F I R E P R O T E C T I O N ( O P T I O N AL )
Fire-Zone Alarm
If a fire is detected, the fire alarm signal will turn on, “FIRE” will be displayed and the
keypad sounder will pulse.
1 If a fire is in progress, evacuate the premises immediately! If necessary, call the
Fire Department from an outside phone.
2 Press the
C
button to silence the keypad sounder.
3 If there is no evidence of a fire, enter your User Code and press
U
to turn off the
alarm.
4 Check smoke detector(s). If a smoke detector tripped, its red alarm indicator light
will be on.
5 After the alarm condition is corrected (thermostat cooled down; smoke cleared
from detector; etc.), pressing
C
again will reset the keypad within about 30
seconds.
NOTE: When the Fire Zone is reset, the FIRE icon on the left side of the display will
go out after 20 seconds. If the FIRE icon is still displayed, the fire zone has not
been properly reset. If you cannot clear this condition by pressing
C
, call for
service.
Fire-Zone Trouble
1 If a problem in the fire-circuit is detected, “FIRE TBL” will display and the sounder
will pulse to signal a malfunction.
2 Press
C
to silence the sounder. Call for service immediately!
FIRE
F I R E A L A R M
FIRE
S Y S T E M T R O U B L E
F I R E T R O U B L E