NAPCO GEM-RP8LCD, Operating Manual, Page: 15 / 32

15
DISPLAY
ZN DIRECTORY
Display Zone Directory Zones are independent circuits that protect specific areas of
the premises. The zone directory will scroll a listing of all zones in the Area.
Activate Bell Test
Enter this command to turn on the Bell, keypad sounder, keypad
LEDs and four icons for 2 seconds. The battery is tested during a Bell Test, and
automatically every 24 hours (or 4 depending on the program) to ensure proper
battery operation under load.
Activate Dialer Test
(Dialer Test enabled? ! YES ! NO). Sends a communicator
test to the central station. A communication failure will be indicated at the keypad by a
system trouble “FAIL TO COMM” display. Repeat the test to attempt to correct a
communication failure, as any successful communication will clear this display.
Deactivate Chime The Chime Mode will sound a tone at the keypad when the
programmed zone is faulted while the system is disarmed. To deactivate the Chime
Mode, re-enter the Function Mode and when “DEACTIVATE CHIME“ is displayed,
press
U
. Note: The Chime Mode is disabled while armed.
Deactivate KP Sounder
The keypad sounder is a local warning device at each
keypad. This command turns the keypad sounder ON or OFF. When the keypad is
deactivated, all keypad sounds will be silenced except for keypad feedback beeps and
Keypad Sounder on Alarm.
F U N C T I O N M E N U
ACTIVATE
BELL TEST
ACTIVATE
DIALER TEST
DEACTIVATE
CHIME
DEACTIVATE
KEYPAD SOUNDER