WI850D GEM-P800 Installation Instructions
18
sent, but the event code and subscriber ID
are not transmitted. With this option se-
lected, a telephone number programmed in
Leading Digits or Trailing Digits would send
the telephone number to the pager each
time a report is sent.
(2) Reserved
(3) Reserved
(4) Reserved
Telephone Number 3 Programming
[50] - [59]
Programming is the same as for Telco 1.
Program to split/double report to Telco 3.
Refer to sections [30] through [39].
Report Codes
[60] Zone Report Codes
Report Code for Zones 1 through 8.
4/2 format
- The Zone Report Code is the
1st digit of the report code sent, the second
digit is the zone number of the reporting
zone. For example, if zone 2 has a report
code of
3
, the report code would be
32
.
3/1 format
- Sends only the report Code
and does not append it with the zone num-
ber.
[61] Point ID Report Codes
Point ID Report Codes are defaulted to Bur-
glary for zones 1 through 8. Optionally,
Point ID codes for zones 1 through 8 can be
programmed as follows:
[1] Fire [7] Gas Alarm
[2] Panic [8] Heat Alarm
[3] Burglary [9] Reserved
[4] Holdup [A] Auxiliary
[5] General Alarm [B] 24 Hour
[6] Reserved
[62] Zone Codes
[62-1]
Restore code
- Zones 1 through 8.
The second digit of the restore code is the
zone number of the restored zone. For ex-
ample, if the Zone Restore Code [62] is pro-
grammed to
E
, the restore code for that
zone would be
E4
(4/2 format).
[62-2]
Trouble Code
- Conditional Closing
Reports. Zones that are bypassed at the
time of arming send this code along with the
zone number of the bypassed zone(s). For
example a conditional closing by User 2,
with zones 2 and 3 bypassed would be as
follows:
1234
C
2
F
2
F
3
[63] System Report Codes
Program a 2-digit report code for
Keypad
Fire, Keypad AUX, Keypad Panic, Test
Timer, AC Fail, Low Battery, Trouble and
Fire.
[64] System Restore Code
The code sent when a system condition
restores. The second digit of the 2-digit
restore code is the second digit of the Sys-
tem Report Code [63]. For example, if a
Low Battery System Report Code is F8 the
Battery Restore would be E8 (4/2 format).
[65] Opening and Closing Codes
Program Opening and Closing Codes for
Users 1 through 8. The second digit of the
report code is the number of the user that
armed or disarmed the system. For exam-
ple, if the Closing Code [65] is programmed
with a
C
, the closing code for User 2 would
be
C2
(4/2 format).
[66] Ambush Report Code
Program a 2-digit report code for Ambush.
To send an ambush report, program a User
Code for User 8, Program report User 8 as
Ambush [20-4] and Select reporting for
Telco 1 [36-2] and/or Telco 3 [56-2].
