17
[42] Receiver Format (Telco 2)
Select the format that will be used to report
for Telco 2 (Backup reporting). Refer to
section [32].
[43] Receiver Options (Telco 2)
Refer to section [33] Receiver Options.
[44] Dialing Prefix
Dialing prefix for Telco 1, Telco 2, and Telco
3. Program if using an Outside access num-
ber.
[45] Communicator Features 1
(1) Communicator Enabled
- Program to
enable the communicator.
(2) DTMF with Rotary Backup
- The first
attempt to communicate is dialed using the
TouchTone method of dialing, subsequent
attempts are dialed using the pulse method
of dialing. Disable this feature to dial using
only rotary dialing.
(3) DTMF only
- All attempts to communi-
cate dial using the TouchTone method of
dialing.
(4) Backup Reporting to Telco 2
- After 2
attempts are made to communicate to Telco
1 the backup phone number is dialed (Telco
2).
[46] Communicator Features 2
(1) No Dial Tone Detection
- Program to
disable dial tone detection for Telco 1, Telco
2 and Telco 3.
(2) 2:1 Rotary Dialing
- Changes the
make break ratio when rotary dialing from
1.5:1 to 2:1.
(3) Backup if < 4 attemps
- If
Backup
Reporting
[45-4] has been enabled, the
communicator will use
Telephone Number 2
[41] for the remaining retries when there are
less than 4 retries remaining.
(4) Reserved
Pager Programming
If Pager Format ([32]and/or[42]and/or[52] =
7) is selected, pager data will be displayed
as shown in Figure 8. If Pager Format is
selected 4/2 format must be programmed
and Sumcheck is not permitted. If a PIN
number is required refer to Leading Digits
[47].
Pager Alarm data is the same as 4/2 format
with the exception that the 2 digit Report
Code is transmitted before the 4 digit Sub-
scriber ID.
[47] Leading Digits
Pager PIN Number
- If a PIN number is
required by the paging system, program the
PIN number in the Leading Digits location.
See sample program below.
If a 7-digit PIN number is required, program
the panel as follows:
[31]/[41]/[51] - Pager Telephone number
[32]/[42]/[52] - Select Pager Format
[47] -
X X X X X X X C
Leading and Trailing digits can be letters B,
C or D. B = the * button on a telephone, C =
the # button on a telephone, D = 2 second
delay.
[48] Trailing Digits
Transmitted after alarm data. Refer to sec-
tion [47] for programming information.
[49] Pager Options
(1) Skip Alarm Data
- Once pager format
is selected, program this option to skip
alarm data. If this option is selected, all the
programmed Leading and Trailing digits are
000 033-1234
Leading Digits
Report Code
Subscriber ID Number
FIGURE
8
D
EFAULT
P
AGER
D
ISPLAY
7-digit PIN Number
Terminating Digit (#)
Digits in Report Codes and subscriber IDs that are pro-
grammed with "B" through "F" will be converted to "0"s.
N
OTE
:
